its a DIY project, but a drunken rambling

[Redpappy]

Sorry no Pics available, but I have a brew stand ( single tier (BIAB)) I plan on putting it on my back porch (instead of my garage). Heres the issue that I have right now that I am working on trying to figure out what to do.. The stand(basically a rectangle box) I can roll around and stick under my covered porch with no issue. But my issue is that I am a BIABer. With the height of my stand, and if I add a high enough pully system, then I will not be able to roll it into my covered porch(though a 7 foot door). So I am in the process of trying to figure out how to temp attach a pully system. Through some research I may have a solution.(ideas from other HBT members). But of course I still need to do some measearments.....as statements says, drunken Ramblings.....

I was going to post in DIY, however with no pics, and a bit tipsy, and just wanted to through stuff out there..... I figured it should go in this one..... I probably should of added this to my other topic ( awful hobby)....... Any who, thanks for listen to a tipsy rambling

 

[JohnSand]

I would build a sleeve to hold the hoist and pull it out for storage.

 

[jrgtr42]

Some sort of folding support would help. Either removable, on maybe a partial sleeve near the bottom and bolts with wing nuts near the top, or some sort of hinge arrangement would work.
Without seeing what you're working with, it's hard to say for sure.

 

[CKuhns]

Lets try this..... hold my beer.