awoitte
Well-Known Member
- Joined
- May 9, 2017
- Messages
- 184
- Reaction score
- 21
Lady at the homebrew shop said the smaller tubing in the photo would work fine for my primary regulator valve. I set my primary at 40-50 PSI. This tubing isn’t very thick but it’s what she recommended and my run is very short so it was less than $3. I could find out myself if it’ll work in practice but wanted to hear from others if standard tubing like this is sufficient to hold that type of pressure.
The thicker/larger tubing is a bottle fill setup I got from NB or morebeer and is 5/16” ID and 9/16” OD for perspective
Thoughts?
The thicker/larger tubing is a bottle fill setup I got from NB or morebeer and is 5/16” ID and 9/16” OD for perspective
Thoughts?