BassManNate
Member
Finally doing my first run for this new system! This is my first real biab in one vessel so I'm hoping this goes much faster than mashing in a bucket and heating on the stove.
Thanks to Bobby_M for the kettle set up! The welding is top notch on this thing!
I built the controller myself with an inkbird ITC-106. Enclosure is from a commercial power supply that was going to be scraped at work. I covered the label on it only because I don't know how the family that owns the company would feel about their name being on this thing!
I've set up right next to the washer partly to get the 240vac from the dryer outlet but also to have a good place to drain my chiller. Going to do a load of laundry after this!
Thanks to Bobby_M for the kettle set up! The welding is top notch on this thing!
I built the controller myself with an inkbird ITC-106. Enclosure is from a commercial power supply that was going to be scraped at work. I covered the label on it only because I don't know how the family that owns the company would feel about their name being on this thing!
I've set up right next to the washer partly to get the 240vac from the dryer outlet but also to have a good place to drain my chiller. Going to do a load of laundry after this!