I'm sooooooo close to finishing my build and I'm down to wiring switches and I'm going crazy trying to get the switches I have to light up when the send power. I can get them to work but without the light. I've been going nuts searching and can't find a good pic. I'm a very visual person so here are some pics of what I have.
The feed coming in is on the right and goes to the distribution blocks. the ground bar will eventually be attached to the frame.
This is the switch wired and working with no light
And here is the switch itself. It is a basic selector switch from automation direct with a normal light. The contact is a normally open one. Please help I'm at my wits end and I know this is something easy that I'm looking over.
The feed coming in is on the right and goes to the distribution blocks. the ground bar will eventually be attached to the frame.
This is the switch wired and working with no light
And here is the switch itself. It is a basic selector switch from automation direct with a normal light. The contact is a normally open one. Please help I'm at my wits end and I know this is something easy that I'm looking over.