udt89
Well-Known Member
So I scored this stand and three keggles a while back. I have two burners I just bought in the classified section. The H205 which can be found here:
http://morebeer.com/view_product/17245/beerwinecoffee/Propane_Burner_-_55000_btu
Two large items I need would be a pump and plate chiller. Everything after that would be tubing and various hardware. What I am looking for from you guys is to basically walk me through what I need and how to set it all up. Your thoughts on mounting the burners, plate chiller, pump, and helping me select the right fittings and other hardware I need to make this whole setup tick. I included a pic of some various hardware that was included in my purchase.
I was thinking of using 3/4" plywood (not sure it will hold weight) on the lowest part on the top and using a stand burner for my HLT. I dont know why he welded those tabs on all three levels of the top half of the stand......
What would you recommend I do to clean up the rust? Obviously sand it down but should I paint it?
http://morebeer.com/view_product/17245/beerwinecoffee/Propane_Burner_-_55000_btu
Two large items I need would be a pump and plate chiller. Everything after that would be tubing and various hardware. What I am looking for from you guys is to basically walk me through what I need and how to set it all up. Your thoughts on mounting the burners, plate chiller, pump, and helping me select the right fittings and other hardware I need to make this whole setup tick. I included a pic of some various hardware that was included in my purchase.
I was thinking of using 3/4" plywood (not sure it will hold weight) on the lowest part on the top and using a stand burner for my HLT. I dont know why he welded those tabs on all three levels of the top half of the stand......
What would you recommend I do to clean up the rust? Obviously sand it down but should I paint it?