johns
Well-Known Member
Here is a picture of the keg washer. If you are wondering why the grey wire wrapped around the PVC, it is to hold it down in place. There is a fitting that screws into the base of the pump. Then a slip fit reducer coupler that connects to the 1/2 PVC pipe. If I had glued everything together, there would have been no way to screw the bottom connector into the pump because the "T" assembly would not clear the pump when turned. All of the PVC fittings are glued together except for where the reducer slips into the bottom connector. This way I can disassemble it apart once the grey wire is untied. I do not have a cap with holes drilled in it on the end of the upright PVC pipe. I was afraid of creating too much back pressure by restricting the outflow of water. I usually place a keg or carboy on it for 10 minutes and it comes out spotless.
I also like this setup. what kind of specs does this pump have like the head and GPM? Do you think a small 12 volt pump like show here would work? http://www.ebay.com/itm/270951067871?ssPageName=STRK:MESINDXX:IT&_trksid=p3984.m1436.l2648