Grain mill help

[acarter5251]

I have a corona style mill and it works very well for me. My only complaint is that when I use it, grain goes all over the place. Is there any way I can enclose my mill so that I can still manually crank it, but all of the grain will fall into the bucket rather than on my floor?

 

[grathan]

What about getting it closer to the bucket?

 

[vincentAlpha]

Pretty sure Revvy's got a thread around here that shows his Corona mill setup, looked to be pretty good and I think he had a trick to keep stuff from flying everywhichway.

 

[mash-mongrel]

Cheep, quick easy storage, roll Bristol Board in a cylinder shape the size of the bucket for height extension, cut notches to fit the plank and have the bb overlap at the back by the handle to cut another notch for the crank. Scotch tape and scissors for tools.

 

[CGish]

I did a variation of this for mine:

https://www.homebrewtalk.com/f256/my-ugly-junk-corona-mill-station-90849/index15.html#post1308996

No escaping grain, very little dust.