I'm back into cheesemaking and will be setting all my caves up with a controlled, small fogger (reptile type, one head with any dorm fridge or wine cooler I come across). They'll all have floats, they'll be in fairly large water containers as I hate filling water (and also, like my Savoie tommes needing low air exchange, high humidity and colder temp, I don't like opening doors with some cheeses).
Problem is, I suck at engineering. My previous fogger was beautiful, 9 heads, I think, for my home, large cave in the basement, but it came fully ready to rock. I bought a fan from House of Hydro. The wires are disconnected, they provide twist-caps but honestly, as this is a watery environment, I wasn't sure if I should waterproof everything in the connection, or have it so the connection part is outside the cave, or what.
Secondly, man this is embarrassing, but a square fan base with the round hole they designate. Er, how do you insert the fan through the round hole in your plastic lid? Just start with one side and slide it in, one side at a time? (I'm almost sure not).
Problem is, I suck at engineering. My previous fogger was beautiful, 9 heads, I think, for my home, large cave in the basement, but it came fully ready to rock. I bought a fan from House of Hydro. The wires are disconnected, they provide twist-caps but honestly, as this is a watery environment, I wasn't sure if I should waterproof everything in the connection, or have it so the connection part is outside the cave, or what.
Secondly, man this is embarrassing, but a square fan base with the round hole they designate. Er, how do you insert the fan through the round hole in your plastic lid? Just start with one side and slide it in, one side at a time? (I'm almost sure not).