I've been running a 50amp panel with 3 SYL-2352 PIDs for about 6 years. I recently upgraded the element control PIDs to DSPR-300 EZboils. When they are running at 100% power all is well but when turned down the pulsing makes some of the lights in the house flicker. The flicker is worse with some recently added LED lights than with the incandescents. I put one of the PIDs back in and it flickers too, just not as noticably.
The main house has a 400amp service panel with a 100 amp feeder to my brewing space in a 10ish year old addition. The sub runs an AC/Furnace, washer/dryer, a couple refrigerators and several other circuits. The brew panel is fed from the sub panel by a dedicated 50 amp circuit to a spa panel. All of the breakers are cool to the touch when the elements are firing.
Someone on the Auber Forum said "it could be caused by inductive & capacitive interference in your wiring/system. If you have any inductive or capacitive loads running in your system under the same circuit, it may cause this issue."
Any ideas on possible causes or what I might check? Thanks for reading!
The main house has a 400amp service panel with a 100 amp feeder to my brewing space in a 10ish year old addition. The sub runs an AC/Furnace, washer/dryer, a couple refrigerators and several other circuits. The brew panel is fed from the sub panel by a dedicated 50 amp circuit to a spa panel. All of the breakers are cool to the touch when the elements are firing.
Someone on the Auber Forum said "it could be caused by inductive & capacitive interference in your wiring/system. If you have any inductive or capacitive loads running in your system under the same circuit, it may cause this issue."
Any ideas on possible causes or what I might check? Thanks for reading!