External CO2 mounting

[wit2003]

I have done some searching and get a very broad range of results...

I am looking to see if anyone has examples of different ways they routed their CO2 lines into the keezer other than through the built collar(my build doesnt use a collar).

Im thinking of drilling a hole in the side of the lid, but just trying to see whats been done as far as either a fitting in the hole or just the tube straight through.

As for the tank itself it will be secured on a low shelf next to the keezer.

This is one of the next steps to completing my bar build!

Thanks!!

 

[outside92129]

I called my frige maker and asked for the best location to drill a hole. The phone tech was very helpful and gave me his thoughts after i told him the use case (he thought i was nuts at first). So i just popped a few 1/2" holes, one for each line (multiple regulators for different pressures/beer gas).

 

[wit2003]

Did you just run the tubing through or use a grommet or anything to disconnect the line if need be?