Scored it from work. Feels pretty solid, bolted together, painted steel. Used to hold what I would describe as an industrial looking laminator so I think it should be sturdy.
Decent base for a baby brew stand?
- Thread starter bsdx
- Start date
Help Support Homebrew Talk - Beer, Wine, Mead, & Cider Brewing Discussion Forum:
Scored it from work. Feels pretty solid, bolted together, painted steel. Used to hold what I would describe as an industrial looking laminator so I think it should be sturdy.
Cpt_Kirks
Well-Known Member
Looks like it might hold what, two kegs?
What are you planning to do with it? You going to mount some burners?
Great_Neck_Brewer
Well-Known Member
Free stuff is always good
OP
OP
Its about 6" too short for 3 kegs, most likely target use would be a stand for MLT (and HLT if I ever get one) so I could gravity feed into a floor burner, or maybe a burner stand, the lower level of supports looks convenient for that. Or maybe just a portable table to offload something else around the "brewery". I should put some weight on it and see how it feels.
Here is how the casters look, they are 3 inch:
Here is how the casters look, they are 3 inch:
