Solidsnake
Well-Known Member
So I have searched this forum as best I could and did not find an answer. Has anybody used one of these 12V motors from amazon successfully to motorized a two roller grain mill.
uxcell DC 12V 550RPM Gear Motor High Torque Electric Reduction Gearbox Geared Motor Eccentric Output Shaft
https://www.amazon.com/dp/B01KTZXV06/?tag=skimlinks_replacement-20
They have a range of RPMs but I’m not sure which one would be best since the stated RPM are when under no load.
uxcell DC 12V 550RPM Gear Motor High Torque Electric Reduction Gearbox Geared Motor Eccentric Output Shaft
https://www.amazon.com/dp/B01KTZXV06/?tag=skimlinks_replacement-20
They have a range of RPMs but I’m not sure which one would be best since the stated RPM are when under no load.
Last edited by a moderator: