Mainebrew
Well-Known Member
Sorry fellas, I tried a couple of diff searches with no luck. Has this been done and is there any photo posts on how to?
Thanks
Thanks
I took my single faucet tower and modified it for three taps. The two new ones are on either side of the original and about an inch lower.
I taped it off and drew out my templates. Then drilled a holes along the shape of the circle. Next I used a dremel to cut in between all of the holes and to clean up the circle. My tower is brass that has been painted black, and it was VERY hard to drill into.
I got my shank from Micomatic and the ventimatics from Northern Brewer. If anyone wants pics send an email. And if you want them posted here, send me an email asking that as well.
Enter your email address to join: