michaeljdowling
Member
hello,
i've read a lot on keggle construction and took a crack at it this morning. my cut was rough to say the least and it isn't a perfect circle. the lid i'm using is far from a perfect fit, you can see gaps around it.
is there anyway to fix this? is this keg a throw away (i can just scrap it probably for what i paid for it so i would only lose time).
what i can't find in a lot of these keggle construction tutorials is what people use for lids and does the fit have to be perfectly tight? it's tough because a lot of these stainless lids are like 11.78 inches not a perfect 12 inch. if i'm building a 3 Tier or 2 Tier system is less perfection on the cut better for one not the other?
photos are below, thanks!
thanks!
i've read a lot on keggle construction and took a crack at it this morning. my cut was rough to say the least and it isn't a perfect circle. the lid i'm using is far from a perfect fit, you can see gaps around it.
is there anyway to fix this? is this keg a throw away (i can just scrap it probably for what i paid for it so i would only lose time).
what i can't find in a lot of these keggle construction tutorials is what people use for lids and does the fit have to be perfectly tight? it's tough because a lot of these stainless lids are like 11.78 inches not a perfect 12 inch. if i'm building a 3 Tier or 2 Tier system is less perfection on the cut better for one not the other?
photos are below, thanks!
thanks!