I bought a weldless thermometer/sight glass from Williams Brewing.
Despite taping that sucker up everywhere, the bulkhead leaks at whatever tightness I adjust to and the little O-rings inside for the thermometer can't hold back water. During my last brew session water flowed out so much it actually got inside the thermometer. I fiddled with that thing for a couple hours yesterday and could not get a good seal anywhere, anyway.
Finally just chucked the whole thing and ordered a large Zymico weldless thermometer. I'll have to pick up a separate sight glass later too.
Anyone else have the same difficulty?
Despite taping that sucker up everywhere, the bulkhead leaks at whatever tightness I adjust to and the little O-rings inside for the thermometer can't hold back water. During my last brew session water flowed out so much it actually got inside the thermometer. I fiddled with that thing for a couple hours yesterday and could not get a good seal anywhere, anyway.
Finally just chucked the whole thing and ordered a large Zymico weldless thermometer. I'll have to pick up a separate sight glass later too.
Anyone else have the same difficulty?