Hello everyone,
I'm trying to figure out the simplest way to measure the temp of the outlet from my Mash Tun for a propane fired HERMS set up. I'll be manually controlling the HLT temp, so I don't need any sort of controller.
So far the best I've come up with is a RTD temp probe inside a pipe tee just after the Mash Tun ball valve and then using a $20 Amazon PID controller for temp reading only.
Can anyone think of a cheaper/easier way to do this? Just starting to learn the ropes on E-Brewing so I'm not too familiar with all the gear yet.
Thanks!
I'm trying to figure out the simplest way to measure the temp of the outlet from my Mash Tun for a propane fired HERMS set up. I'll be manually controlling the HLT temp, so I don't need any sort of controller.
So far the best I've come up with is a RTD temp probe inside a pipe tee just after the Mash Tun ball valve and then using a $20 Amazon PID controller for temp reading only.
Can anyone think of a cheaper/easier way to do this? Just starting to learn the ropes on E-Brewing so I'm not too familiar with all the gear yet.
Thanks!