Had a slow leak drain my CO2 tank; thought it was one of my kegs but have identified the problem as the connection of the gas line to the barb on the gas-in disconnect...have already done the following:
- swapped out the disconnect
- cut an inch from the end of the line
- swapped out the hose clamp
- desperately, tried teflon tape on the barb
- switched to 3/16" line (and did all of the above, again)
Still, gas is leaking at this connection. Any suggestions?
- swapped out the disconnect
- cut an inch from the end of the line
- swapped out the hose clamp
- desperately, tried teflon tape on the barb
- switched to 3/16" line (and did all of the above, again)
Still, gas is leaking at this connection. Any suggestions?