phoenixs4r
Well-Known Member
- Joined
- Jun 16, 2011
- Messages
- 1,566
- Reaction score
- 93
I'm motorzing my mill using the instructions from: http://***********/component/resource/article/1171-motorize-your-grain-mill-projects
I have bought all the sheaves and have the motor, however when I went to mount the sheaves, the ID (Which is 1/2) is slightly smaller than the shaft. Are these supposed to be hammered on or should I drill it out?
Thanks in advance.
I have bought all the sheaves and have the motor, however when I went to mount the sheaves, the ID (Which is 1/2) is slightly smaller than the shaft. Are these supposed to be hammered on or should I drill it out?
Thanks in advance.