ElDuderino
Well-Known Member
So I've finally got my little two burner brew stand welded up (my first major welding project with my little 120v clarke stick welder). Here is a picture:
I will post a google sketch up image with measurements in case anyone is interested in using/modifying what I've done.
My question is how are people applying paint to their rigs? I bought some high temperature stove paint and the can recommended not to prime, which makes sense since the primer I have is only rated for 200F and the stove paint is rated for 1200F or so. I sanded it all down to remove any rust marks and I will wipe it real well with alcohol or something to remove any residual oil before painting. Has anyone used this paint and what kind of results did you have? I am open to any suggestions, as I don't have a lot of experience applying finishes to bare metal.
-Jeff
I will post a google sketch up image with measurements in case anyone is interested in using/modifying what I've done.
My question is how are people applying paint to their rigs? I bought some high temperature stove paint and the can recommended not to prime, which makes sense since the primer I have is only rated for 200F and the stove paint is rated for 1200F or so. I sanded it all down to remove any rust marks and I will wipe it real well with alcohol or something to remove any residual oil before painting. Has anyone used this paint and what kind of results did you have? I am open to any suggestions, as I don't have a lot of experience applying finishes to bare metal.
-Jeff