Beer Shank Cap?

[chuggs]

Anybody know who might carry a threaded cap for covering the end of a Keg Coupler or Shank?

I've got a faucet plug...and wanted a Shank cap to go with it. I need it to seal the ends of my Jockey Box for transport so I don't spill beer in the wife's car. I usually flush the coil when I get it home from a party. If I could find a threaded cap...I could seal the back side of the jockey box. The front...I'd either leave the faucet attached, or replace the faucet with the faucet plug (which are readily available)

Just trying to make transporting a jockey box a little neater.

Thanks

Charlie

 

[Schlenkerla]

You could make a DIY cap. Look here for the stuff. Beer Keg Draft System Parts and Fittings - MicroMatic.com

I was thinking a cap with a wing nut, barb end, 1" hose and a plug.

Need it now and real Cheap. One winged beer nut and a few sheets of balled up saran wrap. Jamb it in the nut and screw it on... wah-lah!!!

That will cost you a beer!! PM me for my address!!!

 

[chuggs]

Need it now and real Cheap. One winged beer nut and a few sheets of balled up saran wrap. Jamb it in the nut and screw it on... wah-lah!!!

That will cost you a beer!! PM me for my address!!!

Now you got me thinking...I think a Wing Nut, a piece of a plastic milk jug cut to fit the wing nut, w/ a neoprene washer...and there...no more leaky in wifey's car


Great idea!

Thanks!

Don't have any homebrew on tap right now to sent ya...