Basement Brewery Walls

[augiedoggy]

It is regular frame and drywall behind the diamond plate. But it would be really easy to use an adhesive and stick them to any surface.

I will have to double check the models on the vent hoods but I believe they are range master. I scooped them both up off craigslist for $40 a couple years ago.

I was under the impression that polished aluminum diamond plate would not hold up well cosmetically to spattered acidic and cleaners or wort and it would actually be a pain to clean.(same reasons its not used in kitchens).. do you not have any issues with splatter or spills? if so how is it holding up? I dont myself but then I dont have anything special on my walls to protect them either..
It does look sharp.

 

[Drumminguy81]

I was under the impression that polished aluminum diamond plate would not hold up well cosmetically to spattered acidic and cleaners or wort and it would actually be a pain to clean.(same reasons its not used in kitchens).. do you not have any issues with splatter or spills? if so how is it holding up? I dont myself but then I dont have anything special on my walls to protect them either..
It does look sharp.

It's been excellent for several years now. I also I'm a pretty clean brewer. No splashing or over spray other than behind my sink and even there it still looks fine, maybe slightly hazy but I attribute that to the hardness of my water. I have never even needed to wipe any of it down.