Anyone bought a Monster Mill.

[bradsul]

Just pulled the trigger on an MM-2 with the 1/2" drive shaft! Can't wait to get it and setup my recently acquired motor and VFD!

 

[Monster Mills]

Here's a picture of the new MM-3 just in case you guys haven't seen it. These are shipping right now. We have the stainless roller option available for the 2 and 3 roller mills available right now too, but in limited supply.

Thanks!

~~fred francis
Monster Brewing Hardware

Shown with optional 1/2" drive shaft .

 

[Drunkensatyr]

Damn that is purty!

 

[bradsul]

I wish my budget had had room for that, but I have no doubt I'll be extremely happy with the MM-2 I ordered.

 

[Downunderbloke]

My MM-2 is up and running and crushed its first 20 pounds of grain last week. Motorised @ 150rpm it virtually gobbled its way through in less than 2 minutes! :rockin:

It's da bomb! :fro:

Warren -

 

[cabletech43]

A friend built me this setup for my mill for $75, I was so impressed with it that I had to post it for eveyone to see.the hopper holds about 25 pounds of grain and is detachable for storage.it was made from cabinet grade plywood so it cost a little more but well worth the extra expense.if you would like the same setup email me at [email protected]

 

[cabletech43]

 

[MikeFlynn74]

Anyone buy a MM3 yet? Im curious as to how you like it

 

[mr x]

I have an MM3. It's awesome motorized.

 

[MikeFlynn74]

hopper??? base?

 

[mr x]

https://www.homebrewtalk.com/showthread.php?t=42598&highlight=swing+table

For the hopper, just use a 5 gallon water jug. Simple and cheap.

 

[MikeFlynn74]

Damnit- I cant see pics

 

[mr x]

It's mounted on the bottom of an old maple dresser top with a bodine gear-motor on the top. The gear motor uses a 3:1 pulley reduction to get my speed where I want it.
I cut a hole in the top ans that's where i insert the plastic jug after I fill it. The table is on hinges on the shed wall, so it swings up and out of the way when not in use.