chrisbarnes5000
Well-Known Member
I am trying to put together a bulkhead on my MLT but it keeps leaking. I fear that the problem is that when I made the MLT I drilled the hole with the idea of doing something like Denny's setup with the drilled stopper in the hole. Now that I am putting the bulkhead in I think that I drilled the hole too low in the cooler; leaving very little structure to support a washer. The hole comes down right to where the wall curves to meet the bottom. Has anybody else encountered this, or have any good ideas of how to fix it (I may even entertain getting a new cooler)?
Thanks!
Thanks!