Thank you !,I was just about to unsubcribe to this thread
Think about the flow of gas here, if you can push gas at a variable rate (within the limits of your valves, and zero to 60 or zero to 30 psi ain't alot) you can idle any pressure you want, and I have (like Lonnie and others)a safety shutoff valve on the primary side of the pilot and the valve. To set this up correctly, idle those valves first, then regulate from the source. I can run my 18 tip Jet/wok burners from BIC lighter height to full out F18 Hornet jets safely, with just the right amount of BTU's, it also fixes the yellow flame issues so many people complain about, because they are not 02 starved. The Honeywell issue is simply another fine adjustment place in which you can adjust. I use STC valves, but this will work with all the valves most people use.
Can you show me how you successfully hooked up the 23 or 32 tip Jet burners from CHINA up to a gas source? I found where to purchase it but am confused as there's no accessories like tubings or regulators that come with it. It just says 1/2" or 3/4" pipe threaded openeing. I'm guessing you can attach it from LP propane with regulator and adjust PSI and then plug it straight to the threaded pipe opening? please correct me if i'm wrong. Thanks