Golddiggie
Well-Known Member
Looking for some 1" ID silicone tubing. I'm looking to use some for the outlet on my BK to the pump and maybe some other locations in my setup. Especially for my yeast drop/dump port from the conicals.
I could also go with 7/8" ID tubing if 1" isn't readily available. I do have a line on 7/8" barb with 1.5" TC fittings. But none for the 2" TC fittings. I'd like to go the slightly larger so that it's a more solid fit and doesn't require any clamps. I'd need to get a new set of clamps for use there if I end up with using 3/4" barb fittings.
I have performed Google searches for this, but am leery of ordering from a site I've never even heard of before. If you've ordered from a different (than the normal suspects) source, which positive results, post up a link and I'll check them out. I've looked at all the normal suppliers I use and the largest available (in the stuff you can see into) is 3/4". Putting 3/4" tubing onto 1" barbs doesn't go so well (have yet to get the two to mate). Tips/tricks for that?
I have lengths of both low (10psi burst) and higher (30psi burst) pressure rated. I was planning to use the higher rated for pump driven transfers and the lower for the yeast dumping.
I could also go with 7/8" ID tubing if 1" isn't readily available. I do have a line on 7/8" barb with 1.5" TC fittings. But none for the 2" TC fittings. I'd like to go the slightly larger so that it's a more solid fit and doesn't require any clamps. I'd need to get a new set of clamps for use there if I end up with using 3/4" barb fittings.
I have performed Google searches for this, but am leery of ordering from a site I've never even heard of before. If you've ordered from a different (than the normal suspects) source, which positive results, post up a link and I'll check them out. I've looked at all the normal suppliers I use and the largest available (in the stuff you can see into) is 3/4". Putting 3/4" tubing onto 1" barbs doesn't go so well (have yet to get the two to mate). Tips/tricks for that?
I have lengths of both low (10psi burst) and higher (30psi burst) pressure rated. I was planning to use the higher rated for pump driven transfers and the lower for the yeast dumping.