Hey, I'm hoping I can find a little support in fixing my issue with the Inkbird 106VH. The PID reads the pt100 inconsistently I have 3 of these PIDs and highly considering replacing them, the temperature varies about 2F +/- it's steady for a few seconds than jumps up and down. There is no issue with wiring or "noise" in the panel I've ensured good grounding and shielding of wires. the probe is fine as are the leads. I've tried 3 different leads I've tried another probe, and finally another PID. I had an omron e5cc kicking around which has no output but good for reading temp. The temperature read exactly how I would have hoped my Inkbirds had unfortunately they don't, I hoping there is something I may have missed or overlooked in my testing. I should probably mention to I've auto tuned the InkBirds in troubleshooting the issue.