Nostrildamus
Well-Known Member
I've recently purchased a SanKey keg and may get another to make into a Mash Tun and boil kettle. I have no experience with the weldless fittings I see on Northern Brewer and I was wondering if they would be okay to install in either the vessel as both will have heat applied directly to them. I can't see the weldless fittings, specifically the food grade O-rings holding up under that amount of heat even though the fittings are called "Weldless kettle fittings".
Am I right or are these things okay to use for such purposes? Anyone have any experience with them being good or bad?
Am I right or are these things okay to use for such purposes? Anyone have any experience with them being good or bad?