Hey all.
So all my kegerator parts came in today. I'm converting a Danby DAR340BL 3.4 cubic footer. It's a used fridge and I don't have any manual for it.
http://www.ajmadison.com/cgi-bin/ajmadison/DAR340BL.html
I recently tried the corn starch/alcohol test but was left without any noticible result. I plugged in the fridge (from room temp) and let it run for a a minute or two before spreading the solution across the top (consistency of a thick paint).
The results were pretty inconclusive. Is it possible there are no lines running across the top of this model? Should I leave the fridge running for a certain length of time and try again? The whole mixture seemed to dry out in about 5 minutes so how long do you wait for a result?
Thanks for the advice, I do not want to ruin this baby
So all my kegerator parts came in today. I'm converting a Danby DAR340BL 3.4 cubic footer. It's a used fridge and I don't have any manual for it.
http://www.ajmadison.com/cgi-bin/ajmadison/DAR340BL.html
I recently tried the corn starch/alcohol test but was left without any noticible result. I plugged in the fridge (from room temp) and let it run for a a minute or two before spreading the solution across the top (consistency of a thick paint).
The results were pretty inconclusive. Is it possible there are no lines running across the top of this model? Should I leave the fridge running for a certain length of time and try again? The whole mixture seemed to dry out in about 5 minutes so how long do you wait for a result?
Thanks for the advice, I do not want to ruin this baby