Troubleshooter
New Member
Ok, I have been searching all these threads for some answers to my question and haven't found the answer yet. I am in the stages of researching how to build my AG setup. I am thinking of going Electric with a HERM coil installed in the HLT. I want all my fitting to be tri clover for easy disassembly and cleaning.
So my question is, has any body used tri clover fittings installed on their HLT on the outside and inside of the pot/kettle with out using a coupler? I want all my fittings welded into the pot, so this means welding tri clover ferrules back to back. This would then accommodate the installation of the HERM coil inside the HLT.
If someone has done this what size Ferrules did you use on the inside and outside of the pot?
So my question is, has any body used tri clover fittings installed on their HLT on the outside and inside of the pot/kettle with out using a coupler? I want all my fittings welded into the pot, so this means welding tri clover ferrules back to back. This would then accommodate the installation of the HERM coil inside the HLT.
If someone has done this what size Ferrules did you use on the inside and outside of the pot?