MNBugeater
Well-Known Member
I see videos of stir bars spinning on its proverbial axis and assuming this is the normal operation. I cannot get my stir bar to spin like this, rather it locks on to the magnet and travels in a circular motion all the while attached to the magnet. I get a small dimple or minute whirlpool at the top of the water level and the slurry definitely is being stirred and in good motion.
Any tips to get the bar to spin rather than travel on the magnet? Or is this a 'who cares' 'it doesn't matter' type of event?
Thanks
Any tips to get the bar to spin rather than travel on the magnet? Or is this a 'who cares' 'it doesn't matter' type of event?
Thanks