nicadrick
Well-Known Member
OK, So I finally have the parts needed to build my single tier. I see a lot of great designs, all of which seem to have the base of the kettles set at about belt level?
I am curious why so high off the ground. My thought is to set the kettles at knee height. That lowers the CG of the whole brew rig while operating and also makes it easier to see into the kettles to tend the brew.
My plan is to have the pump(s) as low to the ground as I can with the intake couplers off of elbow set about the top third of the casters. My CFC will sit on the bottom level below the burners.
Let me know how you determined the working height of the kettles for your build. Curious.
Thanks!
I am curious why so high off the ground. My thought is to set the kettles at knee height. That lowers the CG of the whole brew rig while operating and also makes it easier to see into the kettles to tend the brew.
My plan is to have the pump(s) as low to the ground as I can with the intake couplers off of elbow set about the top third of the casters. My CFC will sit on the bottom level below the burners.
Let me know how you determined the working height of the kettles for your build. Curious.
Thanks!