akthor
Well-Known Member
So I'm about a week away from brewing in my new rig. I plan on making 2 batches. Two 1bbl batches so I'm going to need like 80+ gallons of water. I have hard water and a water softener but I also had an RO system installed just for brewing since I knew water from the water softener was no good for brewing.
I know RO systems only make so much water a day. My plan is to harvest it and store it in my 1bbl conicals for my brew day.
My issue is I am unfamiliar with RO systems and how I go about harvesting as much as I can per day. The manual for the RO system says it can make up to 50 gallons per day but it varies on different factors.
So what do I do just turn on the water and will it run until it runs out then I wait a day to do it again? I know it has a storage tank under the sink near the whole filter/membrane assembly the storage tank is 3 gallons. Does that mean I can harvest it 3 gallons at a time? Thanks for any help!
I know RO systems only make so much water a day. My plan is to harvest it and store it in my 1bbl conicals for my brew day.
My issue is I am unfamiliar with RO systems and how I go about harvesting as much as I can per day. The manual for the RO system says it can make up to 50 gallons per day but it varies on different factors.
So what do I do just turn on the water and will it run until it runs out then I wait a day to do it again? I know it has a storage tank under the sink near the whole filter/membrane assembly the storage tank is 3 gallons. Does that mean I can harvest it 3 gallons at a time? Thanks for any help!