Plan9
Well-Known Member
I was given a bunch of Coke pin lock kegs.
I need to see if two will fit in my Sanyo, then clean and refurbish them.
My concern is the lid doesn't have a pressure relief valve like on my ball locks.
It has a safety release molded into the lid, but you can't pull the pressure yourself.
How can you release it on this type?
I can post a picture later.
I need to see if two will fit in my Sanyo, then clean and refurbish them.
My concern is the lid doesn't have a pressure relief valve like on my ball locks.
It has a safety release molded into the lid, but you can't pull the pressure yourself.
How can you release it on this type?
I can post a picture later.