kgfitz
Well-Known Member
just a couple questions
the system i bought did not come with a oxygen tank when i went to the store there was only one brand of oxygen tank to pick from it was bernzomatic. on the back one of the warnings said do not inhale cylinder contents. gas in cylinder is not approved for internal or medical use. is this the right tank or is there another brand that i should buy?
the instructions that came with the kit were not very good it said the best way to sanitize the diffusion stone ( it is a .5 micron stone) is to boil it. i don't know if the black tubing it is attached to is good to boil or not. it is made out of polyethylene. should i take the diffusion stone off the tubing and boil it or is it OK to just put the stone and tubing in the boiling water?
last question what is the best way to clean after use? should i boil the stone again or can i just rinse it off with hot water. is it OK to use oxyclean or pbw on it or will that clog up the stone
thanks for the help
the system i bought did not come with a oxygen tank when i went to the store there was only one brand of oxygen tank to pick from it was bernzomatic. on the back one of the warnings said do not inhale cylinder contents. gas in cylinder is not approved for internal or medical use. is this the right tank or is there another brand that i should buy?
the instructions that came with the kit were not very good it said the best way to sanitize the diffusion stone ( it is a .5 micron stone) is to boil it. i don't know if the black tubing it is attached to is good to boil or not. it is made out of polyethylene. should i take the diffusion stone off the tubing and boil it or is it OK to just put the stone and tubing in the boiling water?
last question what is the best way to clean after use? should i boil the stone again or can i just rinse it off with hot water. is it OK to use oxyclean or pbw on it or will that clog up the stone
thanks for the help