terragady
Well-Known Member
buy what?
buy what?
Hey,
I got my problem with my ardbir
https://youtu.be/72Qz2gnO0hw
https://youtu.be/zs-g5k-HPj4
Edit: SOLVED.
LCD soldered backwards
https://youtu.be/e3uGjVvaO08
Hi,
Im useing Joefarmer version on arduino nano and I have problems with temperature readings.
In my room is 23°C and on display is reading 48,50°C. I tryed to change DS18B20 and its the same :/
Does any have this problem to?
as i recall tbis issue may be due to the setting for the probe being set to outside the vessel as opposed to in it. check the settings for probe location.
I am geting this error, it seems that the sketch is too big for my board. What can i do to reduce it size a little bit?
Arduino: 1.0.6 (Windows 7), Board: "Arduino Uno"
Binary sketch size: 33,614 bytes (of a 32,256 byte maximum)
processing.app.debug.RunnerException: Sketch too big; see http://www.arduino.cc/en/Guide/Troubleshooting#size for tips on reducing it.
at processing.app.Sketch.size(Sketch.java:1653)
at processing.app.Sketch.build(Sketch.java:1586)
at processing.app.Sketch.build(Sketch.java:1562)
at processing.app.Editor$DefaultRunHandler.run(Editor.java:1899)
at java.lang.Thread.run(Thread.java:619)
What heating element will you use? The only bendable element that i found has only 3000W. Will this be enough for boiling 6-7 gallons of wort?
Terragady: did you modify the code from the original ArdBir or Joefarmers version? I'm mainly thinking about pinouts for the various components.
Hi all. I am having troubles wiring my pump relay. It has three inputs and I have 2 wires from the arduino. I can get a green light when I turn the pump on the ardbir but cannot get the red led to turn on and cannot hear a click or anything. Plus no matter how I wire my pump I cannot make it go on. I am using a separate 12v power source for the pump.
Yes, that one with 3 inputs and 3 outputs. If i desolder the relay how should i wire the pump and the shield to it?
A solid state relay for 220V is better, because i will buy a bigger pump, but for now i need to use the 12 v one for testing purpose.
Yes, that one with 3 inputs and 3 outputs. If i desolder the relay how should i wire the pump and the shield to it?
A solid state relay for 220V is better, because i will buy a bigger pump, but for now i need to use the 12 v one for testing purpose.
Yes bionut sorry for the late reply. I am just messing with it now. It's what was said to me by others. The extra junk on the relay board is messing it up. Simply take the positive wire and attach it to the underside here. And viola, works
Enter your email address to join: