I've got some old shanks in a four tap mushroom. These are smaller .5in OD shanks. These shanks take a straight brass tailpiece that goes through a rubber tapered grommet. When the nut slips over the tailpiece and threaded to the shank the rubber is drawn into the shanks sealing it. The rubber is getting a bit ratty. Given the nature of this rubber I would like a source for parts as keeping that all sanitary isn't as easy as the newer all stainless stuff. Anyone seen these and have parts sources?
I've tried all the usual including mcmaster and chi to no avail.
Do I attempt drilling it out and putting in all new?
Also, I'm all set for nitro on the one line and concerned that the higher pressure may be an issue as well.
I've tried all the usual including mcmaster and chi to no avail.
Do I attempt drilling it out and putting in all new?
Also, I'm all set for nitro on the one line and concerned that the higher pressure may be an issue as well.