I bought this kit:
http://stores.kegconnection.com/Detail.bok?no=22
It didn't come with any instructions but it seemed straightforward. Got the CO2 tank filled, hooked up the gas line (to the IN). I opened the CO2 tank with the regulator attached, reads about 750psi. Cranked the regulator to about 10psi because I wanted to try this 'purge' that I hear about of putting CO2 in the keg before I rack into it. However I hooked that gas in line as far onto the post as I can figure it goes, opened the valve on the regulator, and nothing happens. What am I doing wrong? The pressure relief valve on the reg works so it's getting air.
http://stores.kegconnection.com/Detail.bok?no=22
It didn't come with any instructions but it seemed straightforward. Got the CO2 tank filled, hooked up the gas line (to the IN). I opened the CO2 tank with the regulator attached, reads about 750psi. Cranked the regulator to about 10psi because I wanted to try this 'purge' that I hear about of putting CO2 in the keg before I rack into it. However I hooked that gas in line as far onto the post as I can figure it goes, opened the valve on the regulator, and nothing happens. What am I doing wrong? The pressure relief valve on the reg works so it's getting air.