shawnguinn
Well-Known Member
Not sure yet but I will let you know!!! That is my next step, Plumbing
Anybody knows of a good place to get a metal box with a blank face for a control panel development. Even better a place that will cut a custom face plate to my design???? Thanks
Think I'm going with Mr. Heater High Pressure Propane Gas Regulators with POL Fitting, they are 0-30psi adjustable regulators for $20.37 Ineed 3 of them!!!!
http://www.amazon.com/dp/B0002YQP76/?tag=skimlinks_replacement-20
The reviews on that regulator aren't very encouraging... You might be better served with the BC7850 on this page.
Do you really need 3 regulators? You should be able to regulate the input to the gas beam, then use needle valves to tweak pressure to the individual burners. Regulators are great to ensure a constant output pressure when input pressure fluctuates... but needle valves should be able to do the job if you have regulated input to the gas beam. Just a thought.
Looking sweet!
Shawnguinn. Awesome stand...love it
Questions: I noticed you installed your gas manifold (piping) on the rear of the stand? Or is that the bottom front? Didnt know since you have that top rail bar. (which by the way. I will add on other stand I will be building in the future)
What are you going to use to connect to your burners?
Looking great!
I'm thinking of powdercoating this stand but also throwing around painting it. Any body found a good paint that can stand up to the burner heat????
I have done some research on high temp paint and it seems to apply it correctly after the paint dries you have to heat the whole stand up to 400 degrees and keep it there for 2 hours, not sure how to do it to the whole stand. I could do it to the burner surfaces but if you cure one part of the stand and not the other will the rest of the stand chip????
I have done some research on high temp paint and it seems to apply it correctly after the paint dries you have to heat the whole stand up to 400 degrees and keep it there for 2 hours, not sure how to do it to the whole stand. I could do it to the burner surfaces but if you cure one part of the stand and not the other will the rest of the stand chip????
What I did was paint the bare metal with the high temp barbeque paint. On the can itself, It says NOT to use primer. I just painted the surface area where the keggles sit and direct heat is applied. (I painted the entire top)
The rest of the stand I primed and then used epoxy paint.
What I did was paint the bare metal with the high temp barbeque paint. On the can itself, It says NOT to use primer. I just painted the surface area where the keggles sit and direct heat is applied. (I painted the entire top)
The rest of the stand I primed and then used epoxy paint.
I need to find a panel mount digital timer does anybody have any ideas?
I need to find a panel mount digital timer does anybody have any ideas?
Enter your email address to join: