Jester
Senior Member
I have two older kenmoore kegerators and was about to convert one to hold 4 homebrew kegs... well I never thought to test fit them and I never noticed that there was a section in the rear of the kegerator that comes down lower and prevents a keg from being pushed all the way back... basically it looks like I'd have to cut the rubber tops off the keg to somewhere near the top of the handle to get a keg to slide all the way back in there... but even then I dont know if the ball locks with regular fittings will clear... first question... can I cut the rubber off the top of a keg..?? and is there any type of low profile ball locks that will make these fit..?? I hope some one can help me out since I'm in the middle of building a 4 tap tower.. Thanks in advance...
Jester
Jester