Having some issues with the MM3. It's having a very hard time actually grabbing the grains and putting them through the rollers. I used to crush everything at .032" and slowly, we've had to open up the gap and start milling twice - once at .040" and then again at .036". So, obviously, something is going on.
I've seen a lot of posts about others having the same issue, where they've had to take the mill apart, clean and lubricate everything, and then put it all back together. So I think this is what I need to do.
Questions:
1. What exactly am I looking for as far as the root cause of the issue?
2. What kind of lubricant are you guys using? I'd imagine it has to be some kind of food grade something or other, right?
Thanks in advance.
I've seen a lot of posts about others having the same issue, where they've had to take the mill apart, clean and lubricate everything, and then put it all back together. So I think this is what I need to do.
Questions:
1. What exactly am I looking for as far as the root cause of the issue?
2. What kind of lubricant are you guys using? I'd imagine it has to be some kind of food grade something or other, right?
Thanks in advance.