I bought an Igloo 50-Qt square cooler last week for $10 and am trying to put a manifold made of CPVC pipe (1/2 inch) in the bottom. I've got a hole on the side level with the bottom for the drain, and had the pipe cut when I realized I had a choice about design. Better late than never, right
I've got two design and am wondering if there is an opinion (or data) supporting one over the other.
Original idea:
As I was putting it together I noticed I could do this:
In the first I was thinking slits along the long pieces and the short pieces.
In the second slits along the three long pieces. (you can see 4 slits already here before my cutting tool stopped cutting)
Any advice would be appreciated. Thanks
I've got two design and am wondering if there is an opinion (or data) supporting one over the other.
Original idea:
As I was putting it together I noticed I could do this:
In the first I was thinking slits along the long pieces and the short pieces.
In the second slits along the three long pieces. (you can see 4 slits already here before my cutting tool stopped cutting)
Any advice would be appreciated. Thanks