- Joined
- Dec 31, 2017
- Messages
- 75
- Reaction score
- 32
Have a mm3 monster mill. The basic three roller!! Bought the MaltaMuncher motor for it. What a **** show it has been. Spent all morning on day one getting the spider coupling to stop spinning on either side. Once I got that accomplished I was hit with a motor that just won’t turn the mill with gran in it. So I took everything apart multiple times. Check to make sure mill cheek platers were square and they are dead perfect. Double check and reset mill gap. And this motor still insntanly locks up as soon as there is grain in it.
-I had to through drill the mill side and through bolt it. Cause it’s 3/8 and they sent a 10m.
-gap is set to .0325 and it’s perfectly square all they was across.
-my burnt out desalt cordless rips through the grain NOO PROBLEM SLOW OR FAST. STOP AND START WITH OR WITHOUT GRAIN IN MILL!
-I had to through drill the mill side and through bolt it. Cause it’s 3/8 and they sent a 10m.
-gap is set to .0325 and it’s perfectly square all they was across.
-my burnt out desalt cordless rips through the grain NOO PROBLEM SLOW OR FAST. STOP AND START WITH OR WITHOUT GRAIN IN MILL!