RonPopeil
Well-Known Member
this is the fridge:
http://www.sears.com/shc/s/p_10153_...P&srccode=cii_17588969&cpncode=30-121565874-2
i'm trying to do 6 kegs. to pull this off i need to have 2 on the compresseor shelf. i made a collar from 2x6 and from my measurements everything was going to work out. what i couldn't measure was the plastic molding on the underside of the door. with a keg on the shelf (front or back) the plastic molding rubs the top of the kegs.
short story: i need to add like 1/8 inch to the collar just to clear the tops of the kegs. probably not even that much. any ideas? i have weather stripping on the bottom side of the collar. maybe there's a weather stripping product that will add a bit of height? i almost want to cut the molding but so far i've made no permanent changes to the fridge.
http://www.sears.com/shc/s/p_10153_...P&srccode=cii_17588969&cpncode=30-121565874-2
i'm trying to do 6 kegs. to pull this off i need to have 2 on the compresseor shelf. i made a collar from 2x6 and from my measurements everything was going to work out. what i couldn't measure was the plastic molding on the underside of the door. with a keg on the shelf (front or back) the plastic molding rubs the top of the kegs.
short story: i need to add like 1/8 inch to the collar just to clear the tops of the kegs. probably not even that much. any ideas? i have weather stripping on the bottom side of the collar. maybe there's a weather stripping product that will add a bit of height? i almost want to cut the molding but so far i've made no permanent changes to the fridge.