GreenMonti has shown a terrific tool that makes a very nice looking bevel for keggle fittings. I was lucky enough to find a fellow member that was also interested in this tool. And he was able to source the special brass that was needed, and then build the tool for me. Very Cool. Both of you.
So I did a little work the other day. After these guys did all the hard work. This is what I was able to do,
Turned out pretty damn nice. Then I F'd it up welding. Was either too hot or not enough gas flow. I need to work on that. Next one will be better.
Only two things other than my welding job. I drilled a 7/8" hole, that made a very tight fit. Very hard pull, I stretched the all thread and will need to replace it. I have found and ordered a piece of 5/16" Grade 5 all thread. I need to figure a way to determine how far to pull and when to stop.
All in all a nice first try.
Thanks Guys.
So I did a little work the other day. After these guys did all the hard work. This is what I was able to do,
Turned out pretty damn nice. Then I F'd it up welding. Was either too hot or not enough gas flow. I need to work on that. Next one will be better.
Only two things other than my welding job. I drilled a 7/8" hole, that made a very tight fit. Very hard pull, I stretched the all thread and will need to replace it. I have found and ordered a piece of 5/16" Grade 5 all thread. I need to figure a way to determine how far to pull and when to stop.
All in all a nice first try.
Thanks Guys.