dzimm27
Active Member
I am about to start building my controller. I honestly know the DSPR120 is all I need. That said I am intrigued by the possibility of using the timers on the DSPR320 for either heating strike water automatically on schedule for the next morning or potentially for step mashing. I do gluten free brewing so depending on the mash routine I am using I have to add enzymes either all at the beginning (easy) or at each mash step (which at that point I might not want automated steps as I would need to be present to add the enzymes...why not just manually adjust for each step.
I am having trouble finding this in the manual but seem to believe I have read that the step programming can be disabled To basically make the 320 run like the 120 in a neutered mode. I have no problem with the extra 30-ish bucks to get the 320 if I might use it, but just don’t want to end up with something that is annoying to deal with if I don’t use the program modes And just want to turn the dial to adjust target temps. Can anyone with a DSPR320 confirm whether it is a good fit for me with above goals? Thanks in advance!
I am having trouble finding this in the manual but seem to believe I have read that the step programming can be disabled To basically make the 320 run like the 120 in a neutered mode. I have no problem with the extra 30-ish bucks to get the 320 if I might use it, but just don’t want to end up with something that is annoying to deal with if I don’t use the program modes And just want to turn the dial to adjust target temps. Can anyone with a DSPR320 confirm whether it is a good fit for me with above goals? Thanks in advance!