I' m new to posting and this might not be where to ask /but I'm trying to find out information to build a Keezer out of a 5.0 cubic chest freezer and I want to know if it is OK to Drill holes in the side and or the front of chest freezer for placement of the temperature probe. I do not care that I void the warranty on the new freezer. I know it can be done and I know that I DON'T want to drill into the coolant lines and ruin the chest freezer ( I even called the manufacture for help and they wouldn't give me info where the lines went through the chest freezer walls because of liability's they said)
And I have the manual and from drawing schematics it appears that all the gas lines in and out are located in the back wall of the freezer. But I would like to know from someone who has experience so I can know for sure.
Is there anybody here that has a clue about doing this or has done it ?
Please help if you can. THANK YOU !
And I have the manual and from drawing schematics it appears that all the gas lines in and out are located in the back wall of the freezer. But I would like to know from someone who has experience so I can know for sure.
Is there anybody here that has a clue about doing this or has done it ?
Please help if you can. THANK YOU !