Different funnel for jsp mill

[adam01]

Hi all;
I have a 10" jsp mill that has a worn spot towards the middle. The ends of the mill feel brand new (2" each).
The current funnel/hopper only has a 1.5" opening in the center for the grain to fall. I see the smaller mills
have a full width hopper.

I would like to redistribute the grain away from the worn spot but don't know how much of an opening
to use. Speed is not an issue for me. Torque is partially an issue since I use a 3/8 corded drill for the motor.

 

[sibelman]

I would stick with Jack's original width, but modify the location of the opening.