I've had my beloved Danby kegerator for 14 years. and don't want to let go! The temperature read out was at 72 deg. and I knew things were not good. Through the forum I've checked out a few things. I bypassed the compressor and it works. I've check with a multi meter the starter and overheat protector all check out. I replaced the temperature sensor. With a meter I've tested the pc board out and I'm not sure if it's checking out. The temperature sensor plug is showing 4 volts (unit is it plugged in with the temperature & key pad disconnected, method is circuit board pin through the meter to ground) and the key pad pins show 0.4 volts (green wire), 3 volts (yellow wire), 4 volts (red wire) & 4 volts (brown wire). Does this sound right? (I am not an electrician). If this board is ok then off to the key pad & circuit board for the key pad. Any and all comments are welcome! Thanks Bob