TheCartelli
Active Member
Ugh... So I have a fully pressurized corny keg that I was going to tap tonight however the liquid line will not attach. I tried it on my other kegs and there is no problem so it's something with the post or poppet but I just can't figure out what. I already made sure to check that the posts were correct and they are. The only thing I notice is that the poppet on the liquid side that I am trying to connect to sits slightly high perhaps? I don't want to push too hard because... well I don't know, in the back of my mind I feel like it's going to explode haha.
I have no idea what to do. I'm still fairly new to this, it's only my fourth time kegging but my first time using this keg and I have never run into an issue like this before.
Any suggestions or thoughts? Help please! Thanks in advance!
I have no idea what to do. I'm still fairly new to this, it's only my fourth time kegging but my first time using this keg and I have never run into an issue like this before.
Any suggestions or thoughts? Help please! Thanks in advance!