so finally i'm getting everything i need together to go all grain!
my only question right now is about the manifold for my 10 gallon Home depot water cooler.
what is the best way to configure it?
i was thinking of a square configuration, and use my dremel to cut slices in the tubing, say half way through, should the slices be on the bottom or on the top? and should i add tubing in the middle of the manifold?
like this:
------------T------------
| | |
| | |
| | |
------------T------------
|
edit: looks like the boards didnt like my spacing on that ascii pic, second set of lines should be between the T's and the last set on the right hand side going down the manifold.
hopefully that gets the point accoss. and hopefully within the next week or two i'll have my edworts pale ale and some JZ ESB brewing!
thanks for your help
Joe
my only question right now is about the manifold for my 10 gallon Home depot water cooler.
what is the best way to configure it?
i was thinking of a square configuration, and use my dremel to cut slices in the tubing, say half way through, should the slices be on the bottom or on the top? and should i add tubing in the middle of the manifold?
like this:
------------T------------
| | |
| | |
| | |
------------T------------
|
edit: looks like the boards didnt like my spacing on that ascii pic, second set of lines should be between the T's and the last set on the right hand side going down the manifold.
hopefully that gets the point accoss. and hopefully within the next week or two i'll have my edworts pale ale and some JZ ESB brewing!
thanks for your help
Joe